2011-07-25, 12:10 PM
(This post was last modified: 2011-07-25, 12:15 PM by airflamesred.)
OK
Basically create some geometry, a cube for example, clone it and move some or all of the verts. Page 1 of this thread has the naming conventions then use the slider in keynote.
The spring zip on page 5 is still there if you need a practical example.
Basically create some geometry, a cube for example, clone it and move some or all of the verts. Page 1 of this thread has the naming conventions then use the slider in keynote.
The spring zip on page 5 is still there if you need a practical example.