2010-06-03, 01:08 PM
Hello again.
I need advice on custom map bits. I added a house (model) to SoM. However the model turned invisble once i was out of a... I dunno 180 radius of it. It was ineffective, the same goes for a wall i put into SoM.
I noticed how the map pieces have a PRT attached to them. If i could transfer a single obj into objedit, could i then allocate it on the grid, then export it as a PRT somehow?
Also, im getting used to animation now. I'm planning on making a model that animates similar to a model i can view in Diver's Somimp. Then i will use that models CP and hopefully! We'l have an animated model with CP.
I need advice on custom map bits. I added a house (model) to SoM. However the model turned invisble once i was out of a... I dunno 180 radius of it. It was ineffective, the same goes for a wall i put into SoM.
I noticed how the map pieces have a PRT attached to them. If i could transfer a single obj into objedit, could i then allocate it on the grid, then export it as a PRT somehow?
Also, im getting used to animation now. I'm planning on making a model that animates similar to a model i can view in Diver's Somimp. Then i will use that models CP and hopefully! We'l have an animated model with CP.